This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[solved] Enable/disable PGNs in can-adapter in OP2?
In OP1 there was a utility to enable and disable PGNs in the can-device.
Can't find anythin like it in OP2. Is it gone or am I just not searching carefully enough?
I use an Actisense NGT-1 if it matters.Cheers,
Pär W
OpenPlotter - CAN Bus - CAN USB tab: "Open device TX PGNs"
Thanks! How could I miss that? Smile
Pär W

Forum Jump:

Users browsing this thread: 1 Guest(s)