2020-11-11, 08:45 PM
It will work with any reversible drive. So can you get the full range of motion by applying power directly in each direction?
You can measure the current draw moving the rudder to know if the controller can handle it, or it may just overheat and trigger the "over temp" fault until it cools This is somewhat difficult to do.
As far as not moving over the full sweep, did you connect rudder feedback? If so, it's likely the default rudder feedback calibration is limiting movement so you may need to reset and re calibrate this. Otherwise I'm not sure what could limit the range.
You can measure the current draw moving the rudder to know if the controller can handle it, or it may just overheat and trigger the "over temp" fault until it cools This is somewhat difficult to do.
As far as not moving over the full sweep, did you connect rudder feedback? If so, it's likely the default rudder feedback calibration is limiting movement so you may need to reset and re calibrate this. Otherwise I'm not sure what could limit the range.