This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Hydraulic controller and LS drive unit

I think it is now working, I think it was the slightly dodgy test wiring Smile, The clutch seemed to be cutting out when the ram started moving. I have re rigged everything now seem to be getting a full range of movement on the ram, so now I just need to fit it in the boat to try it out, unfortunately probably not till spring.

Is there a consolidated guide on the site to amending the gain and config settings?

I did manage to blow the 10 amp fuse on the controller whilst playing around with the servo.min_speed and period, not sure why

blowing the fuse sounds unfortunate. What did you set the max current to?

It could be that the motor controller is a bit under powered for hydraulic pumps. I should have a high power version available next month.
Not sure sorry, ,I will have a play and see if I can repeat the effect

It has been working smoothly since, but as said no load yet, I will try to simulate load and see how it goes. I will keep an eye out for your new controller

Forum Jump:

Users browsing this thread: 1 Guest(s)