This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Configure SPI MCP3008 on Openplotter 2
#1
How is this done, absent direct support by openplotter? Is there a signal K plugin or some magic words to put in boot/config.txt? 

Or are most people going a different direction for an ADC now.
Reply
#2
Our plans is to add ADS1115 support to openlotter I2C app because the SPI bus is already used by too much devices.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)