This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Moitessier 1 fitting on raspi 4B
I want to upgrade Raspi 3B to Raspi 4B, with the first gen of Moitessier HAT.
It does not fit phisically because they inverted the eth and usb ports.
Is it possible to file the HAT pcb to fit, without damaging anything ?

Thank you

Alberg 30 #597 on Lake of Two Mountains, Quebec, Canada
One thing you can do is to put a stacking header on the GPIO. Something like this (you might want to cut the pins a little shorter)
I filed the PCB and it worked but I absolutely recommend the header expander option.
Thank you... I was scared to file, not knowing about the layers, and some vias are in the way, maybe only ground plane

Alberg 30 #597 on Lake of Two Mountains, Quebec, Canada

Forum Jump:

Users browsing this thread: 1 Guest(s)