2020-07-30, 09:42 AM
(2020-07-30, 09:17 AM)Max1947 Wrote:(2020-07-30, 05:16 AM)nebosa Wrote: But you can find the file
That's a good thing.
Unfortunately, the file is an incorrect file.
Unfortunately the forum software changes the link when I send it.
If you want to start another try please send me your email address as a PM here in the forum
... Thanks friend, the problem is in the Raspy kernel which blocks the "serial" with the MSC card mounted. Thomas, your countryman, is providing ... see: https://forum.openmarine.net/showthread....7#pid15187
We feel and still good wind. Magnificent sunshine today, so sail!
(2020-07-29, 09:51 PM)Rooco Wrote:(2020-07-29, 09:32 PM)Max1947 Wrote:(2020-07-29, 09:27 PM)nebosa Wrote: ahhh now:
sudo dpkg -i moitessier_5.4.51_2.1.0_armhf.deb
https://i.imgur.com/ovsipMq.png
Entschuldigung, aber ich muss zuerst verstehen, was und wie ich mache ... Google macht seinen Job auch auf Deutsch? Wie auch immer, morgen, wenn es immer noch schlechtes Wetter ist, anstatt mit dem Boot zu fahren, werde ich es mit einem neuen Sd von Grund auf versuchen ...
(Sorry but I must first understand what and how to do ... google does its job in German too? Anyway tomorrow, if it's still bad weather, instead of going by boat, I'll try with a new Sd from scratch ...)
You SHOULD NOT install moitessier_5.4.51_2.1.0_armhf.deb!!!!!
You are always trying to install the wrong package.
Use the package found at our web page: https://www.rooco.eu/2018/06/13/firmware...ssier-hat/
Package name: moitessier_1.20200723-1_5.4.51_2.1.0_armhf.deb
Ok, see: https://i.imgur.com/7ZxO6Mz.png
However it seems that the problem is this: https://forum.openmarine.net/showthread....7#pid15187
Just to ensure we are all talking about the same issue. Your problem is, that the installation of the Moitessier package fails due to an input/output error. Is that correct?
This error is caused by using a none compatible Moitessier package / kernel version combination.
I tested the package again yesterday.
This is my setup:
# Raspberry Pi 4 with HAT 1 and HAT 2
# Used OpenPlotter image: 2020-03-24-OpenPlotter-v2-Moitessier-HAT-img
# sudo apt-get update
# sudo apt-get upgrade
# sudo apt-get dist-upgrade --> these commands will install kernel version 5.4.51 on your system
# Download the latest Moitessier package (moitessier_1.20200723-1_5.4.51_2.1.0_armhf.deb) from our web page: https://www.rooco.eu/2018/06/13/firmware...ssier-hat/
# Install the package: sudo dpkg -i moitessier_1.20200723-1_5.4.51_2.1.0_armhf.deb
# Check if HAT is accessible (after reboot): cat /dev/moitessier.spi