problem installing moitessier firmware [closed]

[jamieFL]

...  Thanks friend, the problem is in the Raspy kernel which blocks the "serial" with the MSC card mounted. Thomas, your countryman, is providing ... see: https://forum.openmarine.net/showthread....7#pid15187

We feel and still good wind. Magnificent sunshine today, so sail! 

---

Ok, see: https://i.imgur.com/7ZxO6Mz.png

However it seems that the problem is this: https://forum.openmarine.net/showthread....7#pid15187  

Just to ensure we are all talking about the same issue. Your problem is, that the installation of the Moitessier package fails due to an input/output error. Is that correct?
This error is caused by using a none compatible Moitessier package / kernel version combination.

I tested the package again yesterday.
This is my setup:
# Raspberry Pi 4 with HAT 1 and HAT 2
# Used OpenPlotter image: 2020-03-24-OpenPlotter-v2-Moitessier-HAT-img
# sudo apt-get update
# sudo apt-get upgrade
# sudo apt-get dist-upgrade --> these commands will install kernel version 5.4.51 on your system
# Download the latest Moitessier package (moitessier_1.20200723-1_5.4.51_2.1.0_armhf.deb) from our web page: https://www.rooco.eu/2018/06/13/firmware...ssier-hat/
# Install the package: sudo dpkg -i moitessier_1.20200723-1_5.4.51_2.1.0_armhf.deb
# Check if HAT is accessible (after reboot): cat /dev/moitessier.spi

Okay, this gives me: https://i.imgur.com/EJeeu5j.png

Tonight I will try with a new SD on Raspy 4 and HAT v.1 and without MCS card. I'll let you know. Thanks anyway and good wind! 

If you get this output, Moitessier package is installed correctly and HAT is working as expected.
Do you face other problems or is issue solved now?

  https://i.imgur.com/tdPAYOP.png

Eureka, it works !!! I will check well later, ciao and thank you!

Is it working with the MCS, or without? I have the MCS and Im in the same state you have been and have been waiting for a resolution.