This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Deconz Bridge // Aqara Sensors
I have a Home Assistant on a Rasperry pi running at home with easy integration of aqara sensors via Deconz bridge from Dresden Electronic.
These sensors are very easy to handle for me as a newbie for I.e. bilge water detection or high high alarm on water tank.

Is there any chance to use these sensors or the Deconz software via Openplotter?

Maybe someone here has a deeper knowledge and knows a solution, even without the documentation mentioning this (or knowledge of protocols etc is missing on my side).

Aqara sensors use zigbee protocol. On the pi you have hardware to receive data from zigbee. This hardware often works with node-red. In node-red you can send data to SignalK.
On my Openplotter setup, Im using some Aquara sensors with a CC2531 adaptor and ZigbeeToMQTT software. This gets the data into MQTT and then i use NodeRed to pull it into SignalK and ultimately InfluxDB. Its a long winded way to get the data there, but it works...

Forum Jump:

Users browsing this thread: 2 Guest(s)