This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ADS1115 setup
#1
Hello,

I just connected an ADS1115 to my raspberry with Openplotter (moitessier hat edition), but I really don't know how to start to configure it? I juste connected a thermistor on the ADC to do some tests.
I tried to launch I2C app, but nothing about the ADS1115. 

I didn't find any documentation explaining step by step how to make it work...

Searching on the forum, I understand that I probably have to edit a file, but which one? 

If someone can help me!

Thank you!

Nicolas
Reply
#2
After lot of research. Is the ADS1115 is yet compatible with RPi4 and OP2 ?

Nicolas
Reply
#3
ADS1115 is the next in the TODO list
Reply
#4
(2020-09-14, 06:48 PM)Sailoog Wrote: ADS1115 is the next in the TODO list

I do it remotely, using an ESP32 and send the signal over wifi to the OpenPlotter. 

Using the ADS1115 or any of the other I2C or SPI ADCs are straightforward using the ESP32.

You can take a look at this page :   https://sites.google.com/site/olewsaa/ya...all-sensor

Using wireless you also get perfect isolation of your computer setup, no stray current, common noise etc. 

Ole
Reply
#5
new sensors added: https://forum.openmarine.net/showthread.php?tid=3055
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)