This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Moitessier Pitch, Heel, Compass, Temp data Freezes on Cold Restart
#1
Exclamation 
I have Pi 4, Moitessier HAT with MCS.  I've noticed that when I boot my OP from a cold start, I usually, and by usually I mean as often as I can remember, I have to reboot to get pitch, heel, compass, temp, and pressure data to show up in OpenCPN.

Any ideas why this happens?  Is this common? Is there a setting that I can change besides 'Delay' in settings, which i currently have set to 3 seconds, remedy this?
Reply
#2
(2020-08-22, 08:52 PM)jamieFL Wrote: I have Pi 4, Moitessier HAT with MCS.  I've noticed that when I boot my OP from a cold start, I usually, and by usually I mean as often as I can remember, I have to reboot to get pitch, heel, compass, temp, and pressure data to show up in OpenCPN.

Any ideas why this happens?  Is this common? Is there a setting that I can change besides 'Delay' in settings, which i currently have set to 3 seconds, remedy this?

I have the same problems with temperature and pressure, see here:

https://forum.openmarine.net/showthread.php?tid=2506

So far, nothing has happened in this matter...
Reply
#3
openplotter-i2c v2.1.2 should fix this, could you check your version please?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)