This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
AIS Signals in chart

my set: openplotter running in a Raspberry Pi 4, all clean.

In the chart I see the gps Position of my own tug.

Had calibrated a nooelectric stick, using a vhf antenna for the ppm, channel etc.
But what I have to do, to send the signal to signal k and show any AIS-Signals in the chart?

Going to "connections", but what exact connections to create?
Input, output, Network, UDP, signal K. There are many options.
What is the right direction.
I assume, there is one conncetion needed to feed signal key and another one to feed cpn or the chart.

All trying resulting in warnings and no signals in my chart.

I'm living near the river Rhine in Cologne, there is much AIS use by cargo ships.
but no results...

Thx for any help
manual updated with detailed instructions:

Forum Jump:

Users browsing this thread: 1 Guest(s)