This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Reinforced motor controller
#2
The hydraulic controller took up all of my time assembling. I am preparing a lower-cost version for machine assembly and should have prototypes next week. This version is designed for 20 amp continuous duty which covers most hydraulic pumps and large motors. I may make a 30 amp version in the future. Are you sure you really need 25 amps? This is really a lot.

Sean
Reply


Messages In This Thread
Reinforced motor controller - by kinefou - 2020-09-21, 09:22 AM
RE: Reinforced motor controller - by seandepagnier - 2020-09-22, 07:49 PM
RE: Reinforced motor controller - by kinefou - 2020-09-23, 07:07 AM
RE: Reinforced motor controller - by kinefou - 2020-09-25, 12:59 PM
RE: Reinforced motor controller - by hans-martijn - 2020-10-05, 08:35 AM
RE: Reinforced motor controller - by hans-martijn - 2020-10-06, 09:48 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)