This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 3 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3 ways to bring gps to OpenCPN and Pypilot in OP2
#7
another way to get the data to pypilot would be to "output this data as a nmea repeater or autopilot route" checkbox in opencpn connections must be checked. Then the data can be sent on port 20220 to pypilot from opencpn.

I'm not sure why pypilot is unable to directly receive the gps data from signalk though.
Reply


Messages In This Thread
RE: 3 ways to bring gps to OpenCPN and Pypilot in OP2 - by seandepagnier - 2021-03-03, 10:28 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)