2020-10-30, 08:26 PM
(2020-10-25, 07:57 PM)seandepagnier Wrote: it can work at 16mhz if you change fcpu in the makefile but the arduino needs 5 volts for 16mhz. It may work at 16mhz at 3v3 but it's not rated for it.
I have an 8MHz Pro Mini now.
I am seeing these codes in Arduino.py
[['rf035D5D10', 1]] 0.00037687500000060936 0.2049976559999891
[['rf035D5D10', 2]] 0.00036786499998697764 0.2561497400000121
[['rf035D5D10', 3]] 0.00035020900000404254 0.2859260930000005
[['rf035D5D10', 0]] 0.00031145900001661175 0.2873267189999922
baud rate TX: 0.0 RX 0.0
In the configuration menu I can't program any rf buttons
Pressing keys on the remote, then select a command key in the setup menu, nothing.
Am I doing it wrong?
I have no controller or gyro connected , does that matter ?