This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to drive Brushed motors with Brushless ESC's?
#3
Thanks for the feedback.
Yes, I just realised that the SimonK/BLHeli movement is quite old and not fully maintained with the hundreds of Chinese clones.
It was a dream to be able to re-use the drawer full of dirty cheap ESC's to drive brushed motors.
I have a couple o very old (more than 10 years) Mystery ESC's, ATmega with a PCB that is quite close to some supported by BLHeli... I will burn the firmware and see if they dont produce smoke... if they do, I close this page
I will move to a H-bridge and in parallel give a try to the VESC project (not for the PyPilot)
Thanks
Reply


Messages In This Thread
RE: How to drive Brushed motors with Brushless ESC's? - by fleming - 2020-10-26, 02:57 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)