This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wind sensor data directly to Open Plotter
#3
Thanks,
There is something like Mirco-Talkā„¢ Wireless Gateway - by Raymarine
https://www.raymarine.com/instruments/wi...index.html
They say supported connection protocols are: SeaTalkngĀ® / NMEA 2000 (via DeviceNet adaptor) Micronet (wireless)
It costs half of a single display (like T112), so I could have Raspberry for the cost difference.
Would it work? I mean: do you think I'd be able to read the data from this Micro-Talk Wireless Gateway?

It may not be that bad. I just found something like this:
The Newsteo radio receiver for PC : RF to USB key
https://www.newsteo.com/en/datalogger/ga...ceiver-pc/
There might be a chance to read the signal from wind sensor.
I'll keep digging Smile
Reply


Messages In This Thread
RE: Wind sensor data directly to Open Plotter - by msobanie - 2020-10-31, 11:13 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)