2020-12-17, 07:52 AM
(2020-12-10, 08:28 PM)Divemaster Wrote: Thank you for answer, Today i recived BME280 and i connect it in the same way like BMP180 .
BME280 was working perfectly .
BMP180 is visible in Rapsberry - and in Signal K but signal from BMP180 is not visible in Opencpn and or not working on BMP280 and BME280 "drivers".
I dont have knowledge to compare comuniication protocol of that two sensors.
Anyway BME280 works ok BMP180 is vissible but not working.
I would also like to enable support for the older bmp180, while it show up at 0x77 there is no menu entry for bmp180 and hence it does not work, e.g. no data.
While it's possible to upgrade to bmp280 it would be great if the support for bmp180 could be enabled again, my bmp180 sits on a hat and the module is not plugable.
Ole
Ole W. Saastad
web : https://www.homelinux.no https://algol.homelinux.no
https://github.com/olewsaa/Yacht-computer
twitter : olewsaa
web : https://www.homelinux.no https://algol.homelinux.no
https://github.com/olewsaa/Yacht-computer
twitter : olewsaa