(2020-11-02, 07:36 PM)Sailoog Wrote: We have just published a new version of openplotter-i2c (2.2.0) fixing some errors and adding support for new sensors. It is beta again because some of them has not been tested, please report if you do it. This is the current list:
- ADS1115 (new - tested)
- BME280 (updated - tested)
- BMP280 (new - not tested)
- BMP3XX (new - not tested)
- HTU21D (new - tested)
- MS5607-02BA03 (old - tested)
- INA260 (new - not tested)
We have included a new system to allow customized settings for sensors and now it will be easier adding new ones. Please post here to suggest new sensors.
I went to the boat today, and the openplotter I2c 2.20 did not show as an update. Went through the usual steps to find updates to apps several times and it did not show. Usually updates, even Beta ones show. Maybe I missed something. would be willing to Beta test the version 3 openplotter if it will not work with the current ver 2.
Using the 32bit version downloaded in April of openplotter on a Pi 4b with the pican M hat and adafruit bme280 sensor. I have been searching on how to change the address to 76 for the BME280. appears to involve breaking a connection and resoldering. with bifocals and stiff fingers, a software solution is much appreciated.
Have the following sensors I' would like to add to the setup. Adafruit CCS811 Air Quality Sensor Breakout - VOC and eCO2 ,Carbon Monoxide Gas Sensor MQ-7
Thanks very much for working on this. deeply appreciated.