2020-11-06, 11:30 AM
(2020-11-06, 08:16 AM)Andreas29 Wrote: Hi,
here GPIOs you can see how the pin´s of the RPi are counted. Attention, the GPIO-number is not the same as pin-number. Look for the pin-numbers.
What you can try is just change the two data lines at the RPi-pins tx/rx together.
Regards
Andreas
Hi andreas, yes I have seen the GPIO pins. However in my case Seam's directions say (in my case):
- brown wire from controller to pin 1 (3.3v)
- white wire to pin 8 (tx)
- green wire to pin 10 (rx)
- black wire to pin 6 or 9 (GND)
and so I did. I tried to reverse anyway but it doesn't change. The actuator does nothing and in Browser control gives me an error.