2020-11-10, 01:31 AM
I'll watch tomorrow, it's late here. It seems that the USB addressing needs to be changed. The controller is connected to the GPIO ports.
I'll watch tomorrow, it's late here. It seems that the USB addressing needs to be changed. The controller is connected to the GPIO ports.
Here is the end of the message after launching "make upload":
avrdude -P /dev/ttyUSB0 -u -p atmega328p -c arduino -U f:w:motor.cpp.hex -b 57600
avrdude: ser_open(): can't open device "/dev/ttyUSB0": No such file or directory
avrdude done. Thank you.
make: *** [Makefile:75: upload] Error 1
I'll watch tomorrow, it's late here. It seems that the USB addressing needs to be changed. The controller is connected to the GPIO ports.
Here is the end of the message after launching "make upload":
avrdude -P /dev/ttyUSB0 -u -p atmega328p -c arduino -U f:w:motor.cpp.hex -b 57600
avrdude: ser_open(): can't open device "/dev/ttyUSB0": No such file or directory
avrdude done. Thank you.
make: *** [Makefile:75: upload] Error 1