2022-04-23, 09:01 AM
(2022-04-22, 10:37 PM)ironman Wrote: Start with running pypilot_hat at the prompt and post the output here.
Hi. I don’t know how but I am going ahead. Now at the prompt I have run pypilot_hat none and on localhost:33333 I coupled one button to an action to check if it works. It looks
like the coupling Is ok, but when I operate the button , nothing happens. I would expect that , opening the gui opencpn interface or localhost:8080 and operating the button the corresponding parameters change acting on the autopilot too. I checked coupling the button to various actions ( select, auto, +10/-10) but with no result. In my hardware arrangement no hat device nor arduino device are installed.
I am proceeding with my attempts. Your tricks are very appreciated.
Best regards
Francesco