(2022-04-29, 12:27 PM)fsnew Wrote: Hi, you are very kind. You are encouraging me in proceeding on my attempts. So, if i'I am right, I would not need an LCD or hat device to operate a keypad and I am trying to check through the steps you kindly listed above. However I have to solve some problems related to the lack of connection to the pypilot server in browser remote mode. I would report below some outputs in order to check which are my essential issues.
ps. I have installed pypilot as a plugin through Openplotter settings and not from github. Is it a fundamental difference?
Many thanks for your kind assistance.
No worries, I like it when people don't give up. You are right in saying that you can operate a keypad without and LCD or hat device. If you have installed pypilot through openplotter, though, you are likely to have a very old version *). Better leave the 'plugin' in openplotter, but install a fresh pypilot from github over it by following the steps given here. Read the workbook over again; it was intended to take one by the hand.
When you see this :
Code:
failed to run web server: [Errno 98] Address already in use: ('0.0.0.0', 33333)
it means that pypilot_hat is already running. Apart from that, I cannot see major issues.
*) Openplotter provides a(n older) version of pypilot, but adds a few wrapper scripts to it, so pypilot adopts the openplotter look and feel. Pypilot, though, is developed at a much faster pace than the openplotter wrappers are kept up, so the two might be a bit out of sync.