This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wind Sensors
#51
(2020-12-11, 09:24 AM)Geronius Wrote: you probably missed checking the box at the bottom of the page to agree to the code of conduct.
Apart from joining the forum to ask questions to Norbert, you may also check the sensor's tech specs here

Michael

Thanks for the link Michael! That was enough information for me to find the sensors on 2 different suppliers.
I think this project is going to cost more in shipping than in parts! Smile

But I am not doing this to save money, just trying to learn.

I did check the code of conduct box, I have a feeling that since the page is getting translated maybe it's reporting back incorrectly. 

Thanks again 
Peter

(2020-12-11, 01:35 PM)norbert-walter Wrote: Peter you find on Gitlab in the documents my email address. You can me also contact via email.

https://gitlab.com/norbertwalter67/Winds...sensor.pdf

Thank you. I will email you with any questions

kind regards
Peter
Reply
#52
rastam4n keep us updated if you find the parts or alternatives.
Reply
#53
(2020-12-11, 10:28 PM)jim321 Wrote: rastam4n keep us updated if you find the parts or alternatives.

I found the Hall Effect Sensors, unfortunately neither of the suppliers have both.

https://www.mouser.ca/ProductDetail/hone...cycode=CAD

https://www.semiconductorstore.com/cart/...uct=103012

Working with Norbert to get the PCB ordered.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)