This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › Pypilot › General discussion v
vnh5019 output voltage Issue

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
vnh5019 output voltage Issue
CapnKernel Offline
Member
***
Posts: 110
Threads: 11
Joined: Jul 2019
Reputation: 5
#31
2021-01-20, 03:11 AM
(2021-01-14, 12:07 AM)seandepagnier Wrote: div clock changed because at 8mhz I get better performance.

Do you think it will ever be possible to run the motor controller m328 at 3.3V?
Online IRC chat for pypilot: https://kiwiirc.com/nextclient/chat.free...et/pypilot
Find
Reply
seandepagnier Offline
Moderator
*****
Posts: 1,085
Threads: 14
Joined: Jun 2016
Reputation: 29
#32
2021-01-20, 04:45 PM
It's possible, but the angular hall sensors I am using for rudder feedback need 5v. Their output could be divided, but running at 3v3 would still need 5v for this, so 2 regulators instead of one.. The power savings is less than 1mA.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)