2021-01-10, 08:02 PM
Thank you Sean for your answer,
I am using a tv remote which I am trying to configure with irrecord. Everything goes well during the procedure, but after adding the contents of test.conf to the /etc/lircd.conf file, the remote control does not work (although the same procedure works with version 0.12).
I am running this version (10/27/2020) on a Chinese nano arduino.
I checked the ~ / .lircrc file and everything seems to be in place; When doing a 'sudo sv status licd', the response is' run: lircd: (pid 1862) 1149s, normally down; run: log: (pid 569) 1189s'
So much for the info, I'm still looking for the solution
Happy new year to you
cordially
I am using a tv remote which I am trying to configure with irrecord. Everything goes well during the procedure, but after adding the contents of test.conf to the /etc/lircd.conf file, the remote control does not work (although the same procedure works with version 0.12).
I am running this version (10/27/2020) on a Chinese nano arduino.
I checked the ~ / .lircrc file and everything seems to be in place; When doing a 'sudo sv status licd', the response is' run: lircd: (pid 1862) 1149s, normally down; run: log: (pid 569) 1189s'
So much for the info, I'm still looking for the solution
Happy new year to you
cordially