2021-02-02, 02:44 PM
@sean or@CapnKernel.... got the motor.ino uploaded to nano everything hooked up along with the bi directional leveler for tx and rx. voltages allong tx and rx are good 3.1v to pi and 5v to nano.
the pi is still saying no motor controller connected, any troubleshooting i can perform? ive checked voltages, ensured the arduino ide uploaded the motor.ino and the crc.h file successfully, did it twice. all connections look good....
Thank you!
the pi is still saying no motor controller connected, any troubleshooting i can perform? ive checked voltages, ensured the arduino ide uploaded the motor.ino and the crc.h file successfully, did it twice. all connections look good....
Thank you!