the new PI zero board worked!! got communications! the USB communication did not work but the leveler does!
now i got an overcurrent issue, will do some searching on the forum and google... no commands have been sent to the motor driver md10c r3 board through ie through the PWM etc
the exact fault is sync overcurrent_fault
not sure why as nothing is moving on the tiller pilot
i changed some parameters the fault is gone, just need to figure out why the motor driver is not changing directions when i activate the autopilot to hold a course
now i got an overcurrent issue, will do some searching on the forum and google... no commands have been sent to the motor driver md10c r3 board through ie through the PWM etc
the exact fault is sync overcurrent_fault
not sure why as nothing is moving on the tiller pilot
i changed some parameters the fault is gone, just need to figure out why the motor driver is not changing directions when i activate the autopilot to hold a course