Good evening everybody,
I would like do display my SOG on a NASA Clipper easylog ( NMEA display).
My Setup:
Raspberry Pi 4b
USB Reciever
USB RS422/485 Adapter
I used the Documentation to connect the USB GPS to opencpn via SignalK, and i see my position in opencpn.
The manual for the esylog says, it expects RMC. So i set up OpenCPN to output RMC to the serial adapter, which looks ok:
21:24:03 (Serial:/dev/ttyUSB0) $ECRMC,202403,A,4847.784,N,01010.736,E,0.182,0.000,210121,3.360,E,A*07
But the Dispay does not show a SOG.
Here are my settings:
I would like do display my SOG on a NASA Clipper easylog ( NMEA display).
My Setup:
Raspberry Pi 4b
USB Reciever
USB RS422/485 Adapter
I used the Documentation to connect the USB GPS to opencpn via SignalK, and i see my position in opencpn.
The manual for the esylog says, it expects RMC. So i set up OpenCPN to output RMC to the serial adapter, which looks ok:
21:24:03 (Serial:/dev/ttyUSB0) $ECRMC,202403,A,4847.784,N,01010.736,E,0.182,0.000,210121,3.360,E,A*07
But the Dispay does not show a SOG.
Here are my settings: