This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
Filter OUTPUT from SignalK to Opencpn

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Filter OUTPUT from SignalK to Opencpn
Jodel Offline
Member
***
Posts: 63
Threads: 18
Joined: Nov 2016
Reputation: 0
#3
2021-02-10, 02:53 PM (This post was last modified: 2021-02-10, 02:55 PM by Jodel.)
I am confused!.  The only input I have to opencpn is the default one from signalk on port 3000 using signalk protocol.
This is the input I would like to debug and filter.
The only output I have from opencpn is the route data to signal k on 10110.
The NMEA debug window in opencpn only shows NMEA out and not signalk in, as far as I can see.
Find
Reply


Messages In This Thread
Filter OUTPUT from SignalK to Opencpn - by Jodel - 2021-02-10, 02:00 PM
RE: Filter OUTPUT from SignalK to Opencpn - by Jodel - 2021-02-10, 02:53 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)