2021-04-10, 01:41 PM
Hello,
Im currently writing my bachelor thesis about ways to sucessfully send NMEA2000 Format Messenges into an existing NMEA2000-network.
The endgoal is enabling control of the boads rudder with a simple Joystick. For this purpose im searching for an program, which is capable of sending custom NMEA2000 messages into the network. Im currently using a Raspberry PI 4 with openplotter installed and the NGT-1. To this point I have tried Canboat, which sends me back an EOF-Error whenever I try sending using the following code:
In detail it starts reading the bus datastream for a few messages before giving me that error.
Every help and tips would be much appreciated,
best regards,
Jannis
Im currently writing my bachelor thesis about ways to sucessfully send NMEA2000 Format Messenges into an existing NMEA2000-network.
The endgoal is enabling control of the boads rudder with a simple Joystick. For this purpose im searching for an program, which is capable of sending custom NMEA2000 messages into the network. Im currently using a Raspberry PI 4 with openplotter installed and the NGT-1. To this point I have tried Canboat, which sends me back an EOF-Error whenever I try sending using the following code:
Code:
echo 2012-06-17-15:02:11.000,6,59904,0,255,3,14,f0,01 | actisense-serial /dev/ttyUSB0
In detail it starts reading the bus datastream for a few messages before giving me that error.
Every help and tips would be much appreciated,
best regards,
Jannis