This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What is the simplest way to implement a IBT-2 BTS7960 motor controller
also there are counterfeit parts that have the right part number printed but generate much more heat.

The pwm for clutch is planned now 2 people asked about it....
Just few words to add to Sean and IronMan comments.

The IBT2 may be a frustrating experience with bad parts, incomplete soldering, missing components (I have one with missing resistors). On my side, I wanted to test the concept, code compatibility and the drivers behaviors with an oscilloscope. My main concern after these tests is heat dissipation :
 - I am not certain that the board design follows the BTS7960 manufacturer recommendations in term of heat transfer (lateral heat transfer through PCB tracks)
 - The implementation of the radiator on the back of the PCB is by no means enough to transfer heat properly and thermal conductive paste might not be sufficient either at high/continuous current. The reason, at least for the boards I have tested, is the lack of heat transfer through the PCB. A possibility is to increase the amount of solder of the through holes ; I have undertaken the mod for the sake of understanding but it is not very satisfactory in term of design. I may be able to complete observations with IR camera during next weeks but I suspect it will not pass the tests.

I have no ideas about long term reliability (especially with thermal stressing).

Regarding safety, the BTS7960 has a thermal safety control and will shutdown if temperature is too high. The datasheet is rather explicit on the consequence in term of component lifetime reduction should repetitive thermal shutdown occurs. It may advisable to apply the controller thermal sensor (ADC pin 2) directly on one of the BTS7960 rather than on the radiator...

All in all, it may be acceptable as a low cost solution for modest currents (I have tested up to 6A continuous so far) and with some understanding of the necessary checks and modifications to the board and peripherals. Having spare will certainly make sense...

Best regards,

I agree, 6 amps is ok, but 43 amp rating is in doubt

Forum Jump:

Users browsing this thread: 1 Guest(s)