This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Autopilot Errors: no motor controller!
#16
(2021-04-17, 04:21 PM)seandepagnier Wrote: did you disable the seria console in /boot/cmdline.txt ?

When you plug the motor controller in without data, just the red light turns on correct?   The blue led never lights right?

- I have: "plymouth.ignore-serial-consoles" in /boot/cmdline.txt. I have not edited it directly, only disabled through GUI

- No blue LED until I start the pypilot service or pypilot_servo, just the red. But when i run any of those two it lights up, and there is quick blinking from the green and yellow LEDs.
Reply


Messages In This Thread
RE: Autopilot Errors: no motor controller! - by Guttagrynna - 2021-04-17, 04:35 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)