This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
Multiple busses on GPIO

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Multiple busses on GPIO
sebba Offline
Member
***
Posts: 55
Threads: 7
Joined: Jan 2020
Reputation: 5
#9
2022-05-15, 08:38 PM
Hello there,

INA260 should work? I tested today, default 0x40 address, near a BME280 at 0x76.
The BME280 is working nice but no signal from INA260, even it's address is detected

Any advice for debug it?
Fair winds
███ - SV Haimana
Find
Reply


Messages In This Thread
Multiple busses on GPIO - by Puzzler2 - 2021-05-03, 03:19 PM
RE: Multiple busses on GPIO - by jim321 - 2021-05-03, 05:22 PM
RE: Multiple busses on GPIO - by Puzzler2 - 2021-05-04, 03:05 PM
RE: Multiple busses on GPIO - by jim321 - 2021-05-04, 03:55 PM
RE: Multiple busses on GPIO - by Puzzler2 - 2021-05-05, 03:58 PM
RE: Multiple busses on GPIO - by Techstyle - 2021-05-05, 05:31 PM
RE: Multiple busses on GPIO - by jim321 - 2021-05-05, 05:29 PM
RE: Multiple busses on GPIO - by Sailoog - 2021-05-05, 08:02 PM
RE: Multiple busses on GPIO - by sebba - 2022-05-15, 08:38 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)