This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Recommended hardware
#1
Question 
Hiu All,

I am trying (and failing) to build a replacement system for the now obsolete Moitessier HAT.

The only sensor I have working properly is the AdaFruit Ultimate GPS.

I have a MPU9255 MPU-9255 3-Axial Accelerometer + Gyroscope + Magnetometer GY-9255 which does not give me data (separate thread on this forum)

I also have a DVB-T + FM + DAB that may, or may not be working. I have no antenna and am too far away from AIS targets anyway to test properly- but I am getting 0 (NaN %) communication from the device in SignalK. I did follow the documentation, and get a green, active and running openplotter-rtl_ais process, but nothing in SignalK.

It could very well be I have all the wrong hardware, there's a lot on offer, and differences between sensors are, at least to me, not always obvious.

So PLEASE, can someone knowledgeable make a list of reccommended hardware for use with an OpenPlotter (Pi) installation? Maybe even with a link to wiring / installing / debugging? 
Sad to say that I am now seriously looking at alternatives..

Thank you for your support!

Now looking at https://www.exp-tech.de/en/sensors/accel...ed-compass for a compass- anyone already using it?
Reply
#2
you will not get data in Signal k without antenna and AIS targets.
that SDR device will work but it needs calibration

that compass is based on the BNO055 and it will not work properly
Reply
#3
(Yesterday, 05:55 PM)Sailoog Wrote: you will not get data in Signal k without antenna and AIS targets.
that SDR device will work but it needs calibration

that compass is based on the BNO055 and it will not work properly

Hi Sailoog,

Thanks for your reply. 
For compasses I now understand the MPU-9255 is the recommended sensor. Did not know the BNO055 will not work (shame as it seems to be the only one that is tilt-corrected out of the box..?..) 

The broader question is if there is a list of either supported, or unsupported sensors? That might prevent much frustration, at least for some..  Confused

Thanks again!
Reply


Forum Jump:


Users browsing this thread: verkerkbr, 1 Guest(s)