2017-01-22, 08:22 PM
I have OP 0.9 running on a rasperry pi 3
connected a 1 wire temperature sensor succesfully: good read out and good reactions.
I wanted to do some experiments with actions.
As a test i wanted to show a message (=25) if the temperature is getting above 25 C.
this this action completely hangs up de pi3 (processor usage 100%)
If I restart the Pi and OP, the action immediately starts again, and I see the usage of the proccesor rising untill 100% and then it hangs again
I have have been able to disable the action and even remove it during this first minute after restarting. but still the action seems to be active.
I I now just start up the pi (and not OP) after a about one minute I get the message (=25) and the pi hangs up.
Is there a way of editing an action before start up?
thank you,
connected a 1 wire temperature sensor succesfully: good read out and good reactions.
I wanted to do some experiments with actions.
As a test i wanted to show a message (=25) if the temperature is getting above 25 C.
this this action completely hangs up de pi3 (processor usage 100%)
If I restart the Pi and OP, the action immediately starts again, and I see the usage of the proccesor rising untill 100% and then it hangs again
I have have been able to disable the action and even remove it during this first minute after restarting. but still the action seems to be active.
I I now just start up the pi (and not OP) after a about one minute I get the message (=25) and the pi hangs up.
Is there a way of editing an action before start up?
thank you,