This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ICM-20948 (QWIIC) setup or standard i2c
#12
yes, so it is already running as a service

yesterday I rewrote most of the openplotter-pypilot plugin so there were a lot of issues before now fixed in git, I'm hoping to get a revision soon.

If you disable boatimu:

sudo service stop pypilot_boatimu

Then run pypilot_boatimu and see the output, or check journalctl for boatimu output. You cannot run 2 instances at the same time with a single imu sensor and 2 imu sensors and 2 instances is not supported.
Reply


Messages In This Thread
ICM-20948 (QWIIC) setup or standard i2c - by esm - 2021-06-14, 08:31 PM
RE: ICM-20948 (QWIIC) setup or standard i2c - by seandepagnier - 2021-06-17, 01:27 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)