2022-03-04, 11:06 AM
(2022-03-04, 08:22 AM)schrammie Wrote: Jay
Thanks again.
My problem is i know a little bit of programming Arduino, but not linex nor python. So iam a newby on this terminal.
1. I copied direcly your scipt and put it in text editor and saved it unther the same name in the head directory and then run it with the terminal. You saw the results. So iam not sure what iam doing wrong here.
2. My raspberry (pi 4 8 gb) got stuck last week with installing of the new update from signal K so i started from fresh again. I first tried with 1 sensor after reprogramming the adafruit sentence, but with the same result, so i added the second one, fresh from aliexpress and only the bme280 sensor. But iam connected it on the Pican-M ic2 connector. Is it bettre to connect it directly on the ectension row of the raspberry (btwthats very diffycult because you cant get a wire in with the Pican-M i tried for the 1-wire application)?
3. i tried, but where can i find that one? see picture, but he cant find it. With directory is that one? i tried /usr/lib/python3/dist-packages/openplotterI2c
Thanks a lot.
renze
renze,
1. I am sorry I can not help you more with your script.
2. There were some problems with the latest Signal K updates, but I thought they were resolved. Search the forum for Signal K updates.
3. The command I suggested in my first link has no spaces in it. However based on your second picture it looks like the openplotter i2c read python script name has changed. The text editor page shown is the correct openplotter i2c read python script. If you execute this script in a terminal window the results may help you diagnose the problem. The editor page does show the library import correction I referenced in my second link. So I do not have any more suggestions. Sorry.
Good luck.
Jay