2022-03-07, 03:40 PM
Jay,
Thanks! sry for the delay, i had to paint my boat over the weekend!
But iam think iam stuck. So i will try the next strategy:
1. Install a new sd card with new Openplotter, update signalK and start only with the BME280 (not even with the Pincan-m) and hope for the best.
or
2. Buying another type off sensor. I want to have pressure, temp (inside) and humilty. So i found on this forum the BMP280. Will this sensor without problems on the I2C connection on the pincan-m add-on board? Does anybody knows?
Jay thanks again for the great help!!
kind regards
renze
Thanks! sry for the delay, i had to paint my boat over the weekend!
But iam think iam stuck. So i will try the next strategy:
1. Install a new sd card with new Openplotter, update signalK and start only with the BME280 (not even with the Pincan-m) and hope for the best.
or
2. Buying another type off sensor. I want to have pressure, temp (inside) and humilty. So i found on this forum the BMP280. Will this sensor without problems on the I2C connection on the pincan-m add-on board? Does anybody knows?
Jay thanks again for the great help!!
kind regards
renze