2022-03-07, 10:37 PM
(2022-03-07, 03:40 PM)schrammie Wrote: Jay,
Thanks! sry for the delay, i had to paint my boat over the weekend!
But iam think iam stuck. So i will try the next strategy:
1. Install a new sd card with new Openplotter, update signalK and start only with the BME280 (not even with the Pincan-m) and hope for the best.
or
2. Buying another type off sensor. I want to have pressure, temp (inside) and humilty. So i found on this forum the BMP280. Will this sensor without problems on the I2C connection on the pincan-m add-on board? Does anybody knows?
Jay thanks again for the great help!!
kind regards
renze
renze,
I forgot to ask. Did you enable the I2C interface on your RPi? The I2C interfacec is not enabled by default. You need to enable it before an I2C device will work. Go to;
RPi > Preferances > Raspberry Pi Configuration > Interfaces enable I2C
Just checking.
Jay