2021-07-21, 10:03 AM
Hi,
I have some different hardware on the boat. Some Garmin/Nexus things (log + wind) on their network, depth finder connected to a garmin plotter on Nmea0187. The plotter supports both Nmea0187 and Nmea2000.
I've looked around and to get the wind instrument into the plotter someone recommended a Garmin GND 10-box. My question is if you think it would be possible to skip this box and use something else in e.g. SignalK + OpenPlotter on Raspberry pi instead of the GND 10-box . Any ideas on my alterantives?
Kind regards,
f
I have some different hardware on the boat. Some Garmin/Nexus things (log + wind) on their network, depth finder connected to a garmin plotter on Nmea0187. The plotter supports both Nmea0187 and Nmea2000.
I've looked around and to get the wind instrument into the plotter someone recommended a Garmin GND 10-box. My question is if you think it would be possible to skip this box and use something else in e.g. SignalK + OpenPlotter on Raspberry pi instead of the GND 10-box . Any ideas on my alterantives?
Kind regards,
f