2023-06-22, 09:38 PM
The problem with using the offset with the davis sensor is it doesnt account for dead band.
The sensor cannot measure for about 7-13 degrees and this normally should be physically orientated toward the forward direction of the boat. An exception would be on a shunting proa where it would be orientated toward windward.
Adjusting the offset in software works for sensors which have a very small deadband like the ones I 3d printed that use hall sensors rather than potentiometers.
So it is better to orientate it forward, you can open the sensor and rotate the potentiometer inside.
The sensor cannot measure for about 7-13 degrees and this normally should be physically orientated toward the forward direction of the boat. An exception would be on a shunting proa where it would be orientated toward windward.
Adjusting the offset in software works for sensors which have a very small deadband like the ones I 3d printed that use hall sensors rather than potentiometers.
So it is better to orientate it forward, you can open the sensor and rotate the potentiometer inside.