This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pypilot for Dummies -The Uninitiated
#35
I went back and refolowed your directions and deleted the conf files. Then I deleted the pypilot directory and the openplotter-pypilot directory. Then I reinstalled twice. The display comes on now and says 92 No Motor Controller. The motor controller is connected. The pypilot part of openplotter is gone and my only access to the control screen is by typing localhost:8080. That is probably good enough. I would like to have it integrated with the rest of OpenPlotter but its not a show stopper. One big thing is that I can't find Pypilot in the home directory anymore. Its like it was installed somewhere in root.

I ran these last commands and they yied bad results. I assume its because the directory is gone.

pi@openplotter:~ $ sudo service pypilot start
pi@openplotter:~ $ cd pypilot/hat/ugfx
bash: cd: pypilot/hat/ugfx: No such file or directory
pi@openplotter:~ $ python3 generate_version.py
python3: can't open file 'generate_version.py': [Errno 2] No such file or directory
pi@openplotter:~ $ make
make: *** No targets specified and no makefile found. Stop.
pi@openplotter:~ $ ./splash nokia5110
bash: ./splash: No such file or directory
Reply


Messages In This Thread
RE: Pypilot for Dummies -The Uninitiated - by SVHM - 2021-09-13, 04:08 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)