This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Motor data from CAN in OpenPlotter

First, I cannot get any useful information out of the read me post above. Both old and new link to documentation seems to be faulty.

My question:
I am converting my boat to electric drive using Nissan Leaf motors. They present a lot of useful data using CAN.
How do I, in a simple way, get that data shown as gauges in OpenPlotter?

Thankful for all support.

Best Regards

Forum Jump:

Users browsing this thread: 1 Guest(s)