NMEA GPS tor serial GPIO

[tkoning]

Hi Folks, Hi tkonig

From other Hobbies I do have "leftovers": 

RASPI 2
GPS+Kompass: with Ublox NEO-M8N Flight Controller GPS - Honeywell HMC5883L L883 Kompass 

The GPS+ Module has following connections (see Picture):
 Vcc,GND
TXD,RXD
SCL,SDA

How would you connect this device to the RASPI 2 ? 
- Vcc to 3V3 ?pin1 GND pin6
- TXD pin8, RXD pin 10
- SCL pin5, SDA pin3

- Do I have to deactivate gpsd ?

WILL I KILL SOMETHING ?

Thanks in advance
Reinhold

P.S.: I tried to read the whole thread on cruisersforum already 

...click pic to enlarge:

Hi
I have used the ublox gps as well and i have connected tx ublox to rx raspberry gpio pin

You can set the baudrate of the gps with the u center software If needed, apart from this setting there is no need to connect the ublox rx
My ublox works with 3V3 logic levels even with 5V vcc so it is raspberry safe
On the pi 3 you have to set the clockfrequency  (see prevous post of esailing) and you have to disable the console output to the serial port (see instructables mentioned in previous post, only the first partof removing the console reverence is still relevant )
Keep in mind a lot of the information you find about this subject is based on oldtimer versions of raspian
You can select the serial input in open plotter in the normal way

After some tweaking avond the gps now works fine
I have alsof tried the compass but allas no luck there