This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problem regarding using LM336 to stabilize voltage
#1
I use LM336 Diodes for 2.5V voltage regulation as the reference voltage of the DA chip. However, the voltage will decrease continuously over time (the amplitude is not large, about 0.00), and the voltage will also change before and after the circuit is connected to the microcontroller.
I Want to ask how to solve it? I just connect a resistor directly through 5V and then V as in the chip manual. Is the circuit too simple, how can I improve it?
To make each day count!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)