New Py Zero 2 W is Out!

[stelian]

@hans-martijn and @Erickalon: Ok, so restarting works (the "normally down" is there because you did a sv stop before).

One thing which could explain the wrong behaviour on start is that signalk requires some python modules which are loaded later during the boot.

Try this:
- log to the tinypilot using ssh
- type 'nano /opt/bootlocal.sh'
- in the editor, find the line "chpst -utc tce-load -is $PYTHON-urllib3 $PYTHON-chardet $PYTHON-certifi $PYTHON-idna $PYTHON-requests $PYTHON-websocket" and move it from where it is in the file (line 143) to line 80, just above "sv u pypilot"
- save the file, exit the editor
- type 'sudo filetool.sh -b'
- type 'reboot'

@Erikalon : I'm not familiar with OP, but I think that OpenPlotter Pypilot means running the pypilot code on the same computer as OP (not on its dedicated raspberry pi). This is mainly for users who do not use tinypilot but have a single Raspberry PI with a pypilot hat, and which is used as a plotter and a pilot at the same time. This is not your case, so you do not need OP pypilot activated.