2021-12-08, 09:26 AM
I want to make a project about MCP6002 Op Amp circuit. If I were using Channel 1 on an oscilloscope to measure Vin (supplied by a sinusoidal signal), and Channel 2 on the oscilloscope to measure Vout, do I put the o-scope Channel 1 probe right before the input pin of the OPAMP and the o-scope Channel 2 probe right before the output pin of the OPAMP, respectively?
Sorry, stupid question. But I haven't done circuit construction in a while, and I'm trying to refresh my memory.
Sorry, stupid question. But I haven't done circuit construction in a while, and I'm trying to refresh my memory.