This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 1 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
pelagic autopilot compatibility
#1
I would like to optionally drive my Pelagic autopilot actuator with pypilot. I want to interface between the Pelagic Teensy2.0 uC and the Pelagic motor drivers, with some sort of disconnect so I can control with either Pelagic or pypilot. Has anything like this been done? If not it seems like it should just be a matter of getting the controller code right, or am I missing something (pypilot newbe alert).
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)