This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
waveshare 10DOF sensor
#1
Hi All,
I am a newbie to Openplotter and RPI (3b+) and working my way through documentation. After giving up on the GY-91 sensor (they all seem to have some kind of error) I am looking into the waveshare 10DOD sensor. I cannot find the wiring diagram to RPI though. Would anyone point me in the right direction with regards to the setup or advise on a few questions:
1. Any preference or benefit 5 vs 3.3v power feed
2. SDA and SCL pin connections to the RPI are clear, but what about the sensor pins INT and FSYNC? Do they connect to the RPI?

Thank you for your help.

https://www.waveshare.com/10-dof-imu-sensor-c.htm
Reply


Messages In This Thread
waveshare 10DOF sensor - by Newbie1979 - 2022-01-12, 04:10 PM
RE: waveshare 10DOF sensor - by Paul M - 2022-01-12, 05:09 PM
RE: waveshare 10DOF sensor - by Newbie1979 - 2022-01-12, 07:31 PM
RE: waveshare 10DOF sensor - by seandepagnier - 2022-01-12, 05:50 PM
RE: waveshare 10DOF sensor - by baltika_no_9 - 2022-01-13, 09:25 PM
RE: waveshare 10DOF sensor - by Techstyle - 2022-01-14, 01:26 AM
RE: waveshare 10DOF sensor - by Paul M - 2022-01-14, 06:17 PM
RE: waveshare 10DOF sensor - by baltika_no_9 - 2022-01-14, 09:09 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)