2022-01-12, 04:10 PM
Hi All,
I am a newbie to Openplotter and RPI (3b+) and working my way through documentation. After giving up on the GY-91 sensor (they all seem to have some kind of error) I am looking into the waveshare 10DOD sensor. I cannot find the wiring diagram to RPI though. Would anyone point me in the right direction with regards to the setup or advise on a few questions:
1. Any preference or benefit 5 vs 3.3v power feed
2. SDA and SCL pin connections to the RPI are clear, but what about the sensor pins INT and FSYNC? Do they connect to the RPI?
Thank you for your help.
https://www.waveshare.com/10-dof-imu-sensor-c.htm
I am a newbie to Openplotter and RPI (3b+) and working my way through documentation. After giving up on the GY-91 sensor (they all seem to have some kind of error) I am looking into the waveshare 10DOD sensor. I cannot find the wiring diagram to RPI though. Would anyone point me in the right direction with regards to the setup or advise on a few questions:
1. Any preference or benefit 5 vs 3.3v power feed
2. SDA and SCL pin connections to the RPI are clear, but what about the sensor pins INT and FSYNC? Do they connect to the RPI?
Thank you for your help.
https://www.waveshare.com/10-dof-imu-sensor-c.htm